NSS-309L
Specification
JIS Specification: D309L-16
Other Specification: DIN ET1221226
Description
- NSS-309L is a lime-titania type electrode, which gives extra low Carbon 25% Cr - 12% Ni austenitic weld metal
- Spatter free
- Good slag detachability
- Deposited metal has excellent resistance to the intercrystalline corrosion than that of ordinary 309 type due to low carbon content
Application
- Welding of AISI 309S and heat resisting cast steel
- First layer welding of stainless clad steel
Remarks
Technical Data
TYPICAL CHEMICAL COMPOSITION OF ALL WELD METAL DEPOSITS (%):
|
C |
Si |
Mn |
Cr |
Ni |
|
0.03 |
0.37 |
1.88 |
24.02 |
13.21 |
TYPICAL MECHANICAL PROPERTIES OF ALL WELD METAL DEPOSITS:
|
Yield Point
N/mm2 (KSI)
|
Tensile Strength
N/mm2 (KSI)
|
Elongation
%
|
|
430 (43.8) |
565 (57.6) |
43 |
SIZE AND RECOMMENDED CURRENT RANGE: AC, DC (+)
|
DIAMETER (mm) |
2.5 |
3.2 |
4.0 |
5.0 |
|
|
LENGTH (mm) |
300 |
350 |
350 |
350 |
|
|
Current Amp |
Flat |
40 - 80 |
60 - 110 |
90 - 150 |
140 - 190 |
|
Vertical & Overhead |
40 - 80 |
60 - 110 |
- |
- |
|
| Welding Positions: | FLAT, FILLET, VERTICAL UP, HORIZONTAL, OVERHEAD |
| Approvals: | CE |
NOTE:
The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and test results for mechanical properties, deposit, or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design, and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.