SHIELD METAL ARC WELDING (SMAW)

 Printer Friendly Layout

N-8010-G

Specification
AWS Specification: AWS A5.5 E8010-G
JIS Specification: N/A
Other Specification: N/A
Description
  • N-8010-G is a high cellulose electrode specifically designed for vertical down welding of all passes on high tensile pipe
  • These electrodes are characterized by a steady, forceful, and concentrated arc to ensure good penetration and wetting action
  • The slag is fast freezing, minimizing slag interference, and allows for easy control of the weld shape and size

 

TYPICAL CHEMICAL COMPOSITION OF ALL WELD METAL DEPOSITS (%):

C

Si

Mn

P

S

 Ni

0.15

0.20

1.0

0.011

0.018

 0.25

 

TYPICAL MECHANICAL PROPERTIES OF ALL WELD METAL DEPOSITS:
Yield Point
N/mm2 (KSI)
 
Tensile Strength
N/mm2 (KSI)
 
Elongation
%
 
Impact Value
°C, J (°F, Ft-Lbs)
 

510 (74)

635 (92)

29

-29°, 68  (-20°, 50)

 

SIZE AND RECOMMENDED CURRENT RANGE: AC, DC (+), DC (-)

DIAMETER (mm)

3.2

4.0

5.0

LENGTH (mm)

350

350

350

Current Amp

Flat & Vertical Down

70 - 110

120 – 160 

160 - 200

Vertical Up & Overhead

60 - 100

110 - 150

130 - 170

Welding Positions: ALL POSITIONS 
Approvals: N/A

NOTE:

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and test results for mechanical properties, deposit, or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design, and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.

  • Transmission and distribution pipelines up to X-70

 

  • The root pass is deposited in the vertical down position
  • A drag technique is used and the electrode is pressed tightly into the joint
  • The second or hot pass should be deposited as soon as possible after the root pass
  • The current should be high enough to burn out any possible wagon tracks or slag
  • A slight weaving technique is usually employed
  • The filler passes are applied using a weaving technique in order to completely fill the joint
  • Excessive travel speed should always be avoided to lessen any chance of porosity
  • Pre-heat and interpass temperatures between 300ºC and 400ºC are recommended

ABOUT US

For over 40 years, NIHONWELD has been the market leader of high quality welding electrodes in both the domestic and international markets. With Nihonweld, you will WELD WITH COMPLETE CONFIDENCE.
Copyright © 2018 Industrial Welding Corporation
Web Design By WebToGo Philippines