SPECIAL N-6013

Specification
AWS Specification: AWS A5.1 E6013
JIS Specification: D4313
Other Specification: DIN E4342R(C)3
Description
  • Special N-6013 is the most easy to use and all-positional (including vertical down) general purpose rutile coated welding electrode
  • Reduced smoke and fumes
  • Few spattering
  • Steady and smooth arc
  • Self removing slag, which reduces cleaning time
  • Strong and high quality weld metal properties
  • Smooth and easy welding
  • An effortless welding experience
TYPICAL CHEMICAL COMPOSITION OF ALL WELD METAL DEPOSITS (%):

C

Si

Mn

P

S

0.07

0.32

0.41

0.012

0.010

 

TYPICAL MECHANICAL PROPERTIES OF ALL WELD METAL DEPOSITS:
Yield Point
N/mm2 (KSI)
 
Tensile Strength
N/mm2 (KSI)
 
Elongation
%
 
Impact Value
°C, J (°F, Ft-Lbs)
 

430  (62)

480  (70)

28

0°, 65  (32°, 48)

 

SIZE AND RECOMMENDED CURRENT RANGE: AC, DC (+)

DIAMETER (mm)

1.6

2.0 2.5

3.2

4.0

5.0

LENGTH (mm)

275

275 350

350

400

400

Current Amp

Flat

20 - 45

30 - 65 60 - 95

90 - 130

120 - 170

150 - 220

Vertical & Overhead

20 - 45

30 - 65 60 - 95

90 - 130

125 - 160

125 - 190


Welding Positions: ALL POSITIONS INCLUDING VERTICAL DOWN
Approvals: ABS, BV, DNV, LRS

NOTE:

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and test results for mechanical properties, deposit, or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design, and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.

  • Pay attention not to exceed the range of recommended currents
  • Welding with excessive current not only lowers X-ray soundness but also causes increase of spatter, under-cut, and insufficient slag covering
  • Dry the electrodes at 70-100C for 30-60 minutes before use
  • Excessive moisture absorption lowers usability and may result in porosity
  • Excessive drying before use causes less penetration and overheating of the electrode
  • Mild steel fabrications, such as houses, chairs, tables, ladders, etc.
  • Steel windows, iron grills, and fences
  • Container steel
  • Welding of ungalvanized pipes
  • General maintenance and workshop

about us

Industrial Welding Corporation (IWC) was established in 1982 by Mr. H. Ong Hai who had 25 years of welding industry experience (at that time). Since then, IWC has consistently and successfully earned an excellent ...
Copyright © 2018 Industrial Welding Corporation
Web Design By WebToGo Philippines