SHIELD METAL ARC WELDING (SMAW)

 Printer Friendly Layout

N-NiMo-3

Specification
AWS Specification: AWS ENiMo-3
JIS Specification: N/A
Other Specification: N/A
Description
  • N-Ni Mo-3 is a nickel-molybdenum electrode designed specifically for welding Hastelloy® W to itself or to a variety of other alloys used in high temperature service applications.
  • Excellent for joining dissimilar combinations of cobalt, nickel and iron-base alloys
  • Provides good mechanical properties up to 980ºC
  • Should not be use for service applciations in excess of 750 hours
TYPICAL CHEMICAL COMPOSITION OF ALL WELD METAL DEPOSITS (%):

C

Si

Mn

Fe

Ni

 Mo Cr W & Co

0.09

0.80

0.80

5.50

Bal.

 25.70 4.30 2.70

 

TYPICAL MECHANICAL PROPERTIES OF ALL WELD METAL DEPOSITS:
Tensile Strength
N/mm2 (KSI)
 
Elongation
%
 
Hardness
 
689 (100)

26.50

95

 

SIZE AND RECOMMENDED CURRENT RANGE: AC, DC (+)

DIAMETER (mm)

3.2

4.0

5.0

LENGTH (mm)

350

350

350

Current Amp

Flat

70 - 110

100 - 150

130 - 180

Vertical & Overhead

65 - 105

95 - 140

-

Welding Positions: FLAT, FILLET, VERTICAL UP, HORIZONTAL, OVERHEAD
Approvals: N/A

NOTE:

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and test results for mechanical properties, deposit, or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design, and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.

  • Commonly used for jet engine repair and maintenance, gas turbine parts, and rotor hubs
  • Weldability is the same as austenitic stainless steel
  • Keep the interlayer temperature under 100ºC and cool it as fast as possible
  • Keep the welding current as low as possible
  • Dry the electrodes at 150-200ºC for 30-60 minutes before use

ABOUT US

For over 40 years, NIHONWELD has been the market leader of high quality welding electrodes in both the domestic and international markets. With Nihonweld, you will WELD WITH COMPLETE CONFIDENCE.
Copyright © 2018 Industrial Welding Corporation
Web Design By WebToGo Philippines