NM-410

Specification
AWS Specification: AWS A5.9 ER 410
JIS Specification: N/A
Other Specification: N/A
Description
  • NM-410 is used to weld types 403, 405, 410, and 416 types of stainless steel
  • Used for welding overlay on carbon steels to resist corrosion, erosion, and abrasion
TYPICAL CHEMICAL COMPOSITION OF ALL WELD METAL DEPOSITS (%):

C

Si

Mn

Cr

Ni

Mo

0.06

0.41

0.53

12.93

0.42

0.16

 

TYPICAL MECHANICAL PROPERTIES OF ALL WELD METAL DEPOSITS:
Yield Point
N/mm2 (KSI)
 
Tensile Strength
N/mm2 (KSI)
 
Elongation
%
 

310 (45)

530 (77)

35

 

SIZE AND RECOMMENDED CURRENT RANGE: DC (+)

DIAMETER (mm)

Amps

0.8 60 - 180
0.9 70 - 200
1.0 70 - 200
1.2 90 - 250
1.6 200 - 300

NOTE:

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and test results for mechanical properties, deposit, or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design, and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.

  • For welding types 403, 405, 410, and 416 of stainless steel
  • Due to air hardening type of material, preheat the joint to 175°C before welding

ABOUT US

For over 40 years, NIHONWELD has been the market leader of high quality welding electrodes in both the domestic and international markets. With Nihonweld, you will WELD WITH COMPLETE CONFIDENCE.
Copyright © 2018 Industrial Welding Corporation
Web Design By WebToGo Philippines